This unit is capable of accepting 16,000 SCFM of hot air flow for drying product. 4 zone filter design, with pan wash Two rubber drainage belts with knife blade discharge Manual belt tension guides for the cloth filter Variable speed belt drive With two 304SS hood enclosures equipped for hot air circulation with pressure relief panels, bolts to the top of the belts frame The original design had one hot air fan with filter banks that pushed steam heated hot air to the top of the product cake Vacuum for the bottom of the pans was provided by Sutorbuilt rotary blowers,(available at additional cost) These blowers are rated for 13000 cfm and are driven by a 350 HP AC motor. (Motors not available) Blower stock numbers are 206782, 206774, 206775, 206773, 206771, 206772, 206784, and 206781.
Type: Filter
Subtype: Horizontal Belt
Manufacturer: Eimco Shriver
Model: 824
Condition: Used
Material: Stainless Steel 304
Filtration Area: 17.8 m² (192 ft²)
Orientation: Horizontal
8' wide x 24' center to center horizontal belt filter/dryer with a 304SS pan This unit is capable of accepting 16,000 SCFM of hot air flow for drying product. 4 zone filter design, with pan wash. Two rubber drainage belts with knife blade discharge. Manual belt tension guides for the cloth filter.. Variable speed belt drive, by a SM Cyclo horizontal gearbox, driven by a Reliance 7.5 hp motor With two 304SS hood enclosures equipped for hot air circulation with pressure relief panels, bolts to the top of the belts frame The original design had one hot air fan with filter banks that pushed steam heated hot air to the top of the product cake. Vacuum for the bottom of the pans was provided by Sutorbuilt rotary blowers,(available at additional cost) These blowers are rated for 13000 cfm and are driven by a 350 HP AC motor. (Motors not available) Blower stock numbers are 206782, 206774, 206775, 206773, 206771, 206772, 206784, and 206781.
Type: Filter
Subtype: Horizontal Belt
Manufacturer: Komline Sanderson
Model: GRS1/1
Condition: Used
Material: Stainless Steel 304
Filtration Area: 0.93 m² (10 ft²)
SS drainage trough, product feed uniformity screw and SS feed distribution box. Dewatering belt is gear driven by approx 5 HP motor thru gear reducer Gravity drainage zone is about 15' long, is supported by plastic support, and also has (4) rows of plows to enhance the sludge dewatering process. After the wedge section, there is 20" dia perforated SS drum, followed by (8) SS "S" wrap rolls Cake discharge via scraper blade system. Each belt is equipped w/high press wash header and enclosed wash box Unit has pneumatic belt tensioning and pneumatic belt tracking. Control panel is required.