multifunctional Spray dryer system with rotary atomization and baghouse filter. on Zinc Oxide, but can dry other inorganic compounds. This spray dryer is an all welded unit comprised of a chamber and cone with the following dimensions: 3.4m diameter x 4.8m straight side x 2.3m coned bottom, 700mm x 400mm access door. The chamber is equipped with pneumatic hammers for helping powder discharge. This spray dryer configuration has a 2 point discharge system. The rotary atomizer is a Niro type F15-GVWO-NPSS rotary atomizer, serial # 767, Drying gas is supplied by a Niro direct gas fired air heater with Maxon airflow burner type NP-35.5, fabrication # 471, liquid petroleum gas fired, 297 kw nominal load, gas supply pressure 8mbar (min), 21 mbar (max). Product/ drying gases are separated by a bag filter, a 31 square meter (339 square feet) Includes the following optional accessories: (1) Brass Hydra-cell spray pump, type G16XDTHFECA, serial # 142602, driven by 2.2/2.55 kw, 3/50/220-240/380-420/440-480 volt, 1420/1720 rpm motor. (1) 1700 liter 304 s/steel feed tank with feed pump, open top, weld coned bottom, 1.4m diameter x 1000mm straight side, Mono Merlin rotary feed pump, type SAB2241VN8, tank and pump mounted on (4) c/steel frame with legs. (1) 250 liter 304 s/steel feed tank with clamp on Lightnin agitator, open top, weld coned bottom, 1.2m diameter x 700mm straight side, Lightnin agitator model LP-75-VH, serial # Q54279, driven by 0.75 kw, 3/50/220/380/420 volt, 1400 rpm motor, tank mounted on (4) c/steel legs. (1) Gericke s/steel centrifugal sifter, type CSM-722-MK2, serial # CM2-7072, 600mm long x 330mm wide,(1) s/steel 3110 m3/hr. @ 160 degrees C fan, manufactured by B.Bille, type HT35-530, fan speed 2900 rpm, 11 kw, 2930 rpm motor. (1) Spiroflow screw conveyor, 60mm diameter x approximately 3m long plastic tube with s/steel screw, driven by 1.75 kw, 3/50/254/277/440 volt, 1115 rpm motor, (1) s/steel 1 ton tote bin, 1m x 1m x 1m deep,