Carbon Steel Blaw Knox Ball Mill - IPP# 79104

Type: Mill

Subtype: Ball

Manufacturer: Blaw Knox

Condition: Used

Material: Carbon Steel

Diameter: 1,829 mm (72 in)

Pressure: 10.7 bar (155 psi)

CS/Ni-hard lined
650 deg F.
2"-6" CS ball charge
Gear driven by 40 HP, 3/60/220/440 volt
thru Falk gear reducer, ratio 32.69:1. Bull and pinion gear ratio 4.85:1.
Unit has Manzel fully centralized lubrication system w/6-station Manzel oil pump
W/control panel and starter box.

Temperature: 343 °C (650 °F). Vacuum: Yes. Powered By: Electric.

Type: Mill

Subtype: Ball

Condition: Used

Material: Carbon Steel

Diameter: 2,135 mm (84.1 in)

conical ball mill
Non drive end ID= approximately 470 mm, (measured at the most narrow point) Drive end ID is approximately 465 mm.
belt driven by motor via bull gear

Type: Mill

Subtype: Ball

Manufacturer: Hardinge

Condition: Used

Material: Carbon Steel

Diameter: 2,135 mm (84.1 in)

Powered By: Electric

conical ball
belt driven by motor via bull gear
Non drive end ID= approximately 470 mm, (measured at the most narrow point) Drive end ID is approximately 465 mm.

Type: Mill

Subtype: Ball

Manufacturer: Hardinge

Condition: Used

Material: Carbon Steel

Diameter: 2,135 mm (84.1 in)

Powered By: Electric

conical balls.
Belt driven by motor via bull gear.
Non drive end ID= approximately 470 mm, (measured at the most narrow point) Drive end ID is approximately 465 mm.