Quote Cart
conical ball
belt driven by motor via bull gear
Non drive end ID= approximately 470 mm, (measured at the most narrow point) Drive end ID is approximately 465 mm.
Type: Mill
Subtype: Ball
Manufacturer: Hardinge
Condition: Used
Material: Carbon Steel
Diameter: 2,135 mm (84.1 in)
Powered By: Electric
conical balls.
Belt driven by motor via bull gear.
Non drive end ID= approximately 470 mm, (measured at the most narrow point) Drive end ID is approximately 465 mm.
Type: Mill
Subtype: Ball
Condition: Used
Material: Carbon Steel
Diameter: 2,135 mm (84.1 in)
conical ball mill
Non drive end ID= approximately 470 mm, (measured at the most narrow point) Drive end ID is approximately 465 mm.
belt driven by motor via bull gear
Type: Mill
Subtype: Ball
Manufacturer: Blaw Knox
Condition: Used
Material: Carbon Steel
Diameter: 1,829 mm (72 in)
Pressure: 10.7 bar (155 psi)
650 deg F.
2"-6" CS ball charge
Gear driven by 40 HP, 3/60/220/440 volt,
Phila gear reducer ratio 30.6:1. Bull and pinion gear ratio 4.85:1.
Unit has Manzel fully centralized lubrication system w/6-station Manzel oil pump.
W/control panel and starter box.
Temperature: 343 °C (650 °F). Vacuum: Yes.
Type: Mill
Subtype: Ball
Manufacturer: Blaw Knox
Condition: Used
Material: Carbon Steel
Diameter: 1,829 mm (72 in)
Pressure: 10.7 bar (155 psi)
CS/Ni-hard lined
650 deg F.
2"-6" CS ball charge
Gear driven by 40 HP, 3/60/220/440 volt
thru Falk gear reducer, ratio 32.69:1. Bull and pinion gear ratio 4.85:1.
Unit has Manzel fully centralized lubrication system w/6-station Manzel oil pump
W/control panel and starter box.
Temperature: 343 °C (650 °F). Vacuum: Yes. Powered By: Electric.