Quote Cart
conical ball mill Non drive end ID= approximately 470 mm, (measured at the most narrow point) Drive end ID is approximately 465 mm. belt driven by motor via bull gear
Type: Mill
Subtype: Ball
Manufacturer: Blaw Knox
Condition: Used
Material: Carbon Steel
Diameter: 1,829 mm (72 in)
Pressure: 10.7 bar (155 psi)
650 deg F. 2"-6" CS ball charge Gear driven by 40 HP, 3/60/220/440 volt, Phila gear reducer ratio 30.6:1. Bull and pinion gear ratio 4.85:1. Unit has Manzel fully centralized lubrication system w/6-station Manzel oil pump. W/control panel and starter box.
Temperature: 343.3 °C (650 °F). Vacuum: Yes.
Type: Mill
Subtype: Ball
Manufacturer: Hardinge
Condition: Used
Material: Carbon Steel
Diameter: 2,135 mm (84.1 in)
Powered By: Electric
conical ball belt driven by motor via bull gear Non drive end ID= approximately 470 mm, (measured at the most narrow point) Drive end ID is approximately 465 mm.
Type: Mill
Subtype: Ball
Manufacturer: Blaw Knox
Condition: Used
Material: Carbon Steel
Diameter: 1,829 mm (72 in)
Pressure: 10.7 bar (155 psi)
CS/Ni-hard lined 650 deg F. 2"-6" CS ball charge Gear driven by 40 HP, 3/60/220/440 volt thru Falk gear reducer, ratio 32.69:1. Bull and pinion gear ratio 4.85:1. Unit has Manzel fully centralized lubrication system w/6-station Manzel oil pump W/control panel and starter box.
Temperature: 343.3 °C (650 °F). Vacuum: Yes. Powered By: Electric.
Type: Mill
Subtype: Ball
Manufacturer: Hardinge
Condition: Used
Material: Carbon Steel
Diameter: 2,135 mm (84.1 in)
Powered By: Electric
conical balls. Belt driven by motor via bull gear. Non drive end ID= approximately 470 mm, (measured at the most narrow point) Drive end ID is approximately 465 mm.